Erico 766PM Far Side Box Support Manual de usuario descargar pdf

Box

Cut here for 4" stud.

For 6" application

use three 766PM.

Cut here.

Note: This device is intended for pushback support and must be used in

combination with an appropiate box hanger support.

Cut here

for 3

stud.

Cut here

for 4" stud.

For 6" application use two

766PM, cut to size.

" Box

For 3

" application

use one 766PM.

For 3

" application

use one 766PM, cut to size.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT:

www.erico.com

CFS415_C

INSTRUCTION SHEET

NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.

The customer is responsible for:

a. Conformance to all governing codes.

b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.

c. Using appropriate industry standard hardware as noted above.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

1 OF 1

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

www.erico.com

and from your ERICO customer service representative.

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

All instructions must be

completely

followed to ensure proper and safe installation and performance.

Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

damage, serious bodily injury and death.

Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.

All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any

other purpose.





 1

Indice de contenidos

Pagina 1 - 

2 18 BoxCut here for 4" stud.For 6" applicationuse three 766PM.Cut here.Note: This device is intended for pushback support and must be used

Comentarios a estos manuales

Sin comentarios

Erico 766PM Far Side Box Support Manual de usuario

Busca en linea o descarga Manual de usuario para Accesorios para eléctrica Erico 766PM Far Side Box Support. ERICO 766PM Far Side Box Support User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios para eléctrica Erico 766PM Far Side Box Support